Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Richmond Hill
Capping and crowning a chimney in Richmond Hill is rarely a one-flue job. Most of the housing here was built in the 1910s through the 1930s as two- and three-family homes, and those shared brick stacks often serve a boiler, a water heater, and an abandoned oil flue side by side. We map every flue before we seal anything, because capping the wrong one can pressurize a neighbor’s. Call (855) 410-4917 and we’ll set up a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Richmond Hill Homeowners Call Chimney Sweep Forest Hills for Chimney Cap & Crown
Richmond Hill is dense, attached, and old enough that the chimneys have stories. The streets off Jamaica Avenue and around Lefferts Boulevard are lined with semi-detached and detached houses packed tight enough that roof access matters, and the stacks themselves have been modified repeatedly as boilers and water heaters were swapped over the decades. We work that housing stock constantly, so we’re familiar with the party-wall layout, the tight side yards, and the way a single address here can have three or four flues feeding one brick chase.
Our technicians have up to 8 years of experience, which is the number we’ll give you straight. We work with professional-grade materials from Gelco, Famco, and Olympia Chimney, so a multi-flue cap is specified for the actual stack rather than a one-size lid bolted over everything. You get a written estimate, and the estimate sets the final price. Nothing is recommended without evidence you can see: our inspection includes photos of the crown, the cap condition, and each flue opening, and it’s your decision whether the crown repair happens now or waits for a season when it’s safer to schedule.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Richmond Hill
Multi-Flue Cap Installation
A multi-flue cap covers the whole masonry stack with a single screened housing sized to the actual flue count. In Richmond Hill’s converted two- and three-family houses, that count is often two or three when the homeowner assumes it’s one, which is exactly the mistake a stock cap makes. We count and map each flue to its appliance first, then fit a Gelco or Famco cover that protects all of them without blocking draft.

Cap Replacement
Rusted-out and missing caps are common on Richmond Hill stacks because many were installed decades ago and never revisited. A failed cap lets rain straight into the flue, and on a shared chase that water finds its way into the party-wall cavity between units. Replacement usually means removing the old frame, checking the flue tile for cracking underneath, and fitting a correctly sized cover on the same visit.

Crown Repair
The chimney crown is the sloped mortar cap at the very top, and on original 1920s brick in Richmond Hill it’s frequently spalling, cracked, or pulling away from the flue. Crown repair rebuilds that slope so water sheds off the stack instead of soaking into the brick and finding freeze-thaw cracks the following winter. This is often the single most effective moisture fix on these older masonry chimneys.

Crown Coating
When the crown is intact but porous, a crown coating seals the surface before it fails. It’s a sensible option on Richmond Hill stacks that are otherwise sound and don’t need a rebuild yet. Ask us to look at the photos first; a crown that’s already cracking through won’t be saved by a coating, and we’ll tell you so plainly.
Trusted Brands We Service in Richmond Hill
We work with professional-grade chimney materials: Gelco and Famco for caps and covers, Olympia Chimney for flexible liner components, and Copperfield where a cap and crown combination calls for it. These are trade brands that a general handyman doesn’t carry or specify. Because our work runs on measurements and mapping rather than stock parts, turnaround stays quick. Call (855) 410-4917 for a free estimate and we’ll confirm what your Richmond Hill stack actually needs.
Common Chimney Cap & Crown Problems We See in Richmond Hill Homes
- Multi-flue stacks capped as if single-flue. A stock cap fitted over one opening while two other flues vent freely. The result is a boiler backdrafting into a neighbor’s flue in the same brick chase, which is the classic Richmond Hill cross-contamination call.
- Spalling mortar crowns on original 1920s brick. Freeze-thaw winters open up hairline cracks in the crown, and water tracks down through the brick into the shared stack and party-wall cavities. Caught early, it’s a crown repair. Left too long, it becomes structural.
- Abandoned oil-boiler flues left uncapped. When an old oil unit was replaced with gas, many flues were never sealed at the top. That leaves an open channel for rain, animals, and downdraft smells into converted upstairs rooms.
- Draft complaints tied to summer heat and winter pressure swings. Humid summers and cold winters both change stack pressure, and a poorly capped or oversized cap can make a flue that worked fine in one season reverse in another.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Richmond Hill, NY
Typical pricing in the Richmond Hill market runs around $250-$550 for a standard single-flue cap installation, $450-$900 for a multi-flue cap on a shared stack, and $400-$1,200 for crown repair depending on how much of the crown is rebuilt. Crown coating sits roughly $300-$600 because it’s a surface application on a sound crown. These are estimates, and the written estimate sets the final price. What pushes a job toward the higher end is the flue count, roof access on a tight side yard, and whether the old liner shows cracking under the cap. The estimate is free, and you’ll get photos with it. Call (855) 410-4917.
We Also Serve Cities Near Richmond Hill
The same multi-flue mapping work carries over to Richmond Hill‘s neighbors. We also schedule cap and crown work in Kew Gardens, Forest Hills, Rego Park, and Middle Village, where the attached housing and party-wall stacks create the same sealing questions. If your building shares a chase with the house next door, tell us when you call. Call (855) 410-4917 for a free estimate.
Serving Richmond Hill, NY – Our Local Coverage Area
We serve Richmond Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Richmond Hill
Yes. An abandoned oil flue left open is the single most common source of water, animal entry, and downdraft smells we find in converted Richmond Hill houses. The old flue should be properly sealed at the top with a cap sized to it, or retired entirely if it’s no longer connected to anything. Call (855) 410-4917 for an exact quote – estimates are free.
Because the two flues share a brick chase, and if one is capped incorrectly or the crown is cracked, exhaust has nowhere to go but into the adjacent flue. It’s a mapping problem more than a smell problem. We identify which flue belongs to which appliance before touching anything. Call (855) 410-4917 for an exact quote – estimates are free.
A multi-flue cap covers all the flues in one masonry stack under a single screened housing, rather than capping one and leaving the others exposed. In Richmond Hill’s two- and three-family conversions, that’s often the only correct fit because the stack serves multiple appliances. Call (855) 410-4917 for an exact quote – estimates are free.
If it’s the sloped mortar crown that’s spalling, it’s usually a crown repair, not a rebuild. A rebuild is only needed when the brickwork beneath the crown has lost structural integrity. Photos from the roof will tell you which one you’re looking at. Call (855) 410-4917 for an exact quote – estimates are free.
Yes. A cap is weather protection and animal exclusion, not just a fire-safety item. Cap work using Gelco and Famco covers is one of the services our chimney cap & crown team handles at the same appointment as a sweep, so it’s an easy add if the flue is open. Call (855) 410-4917 for an exact quote – estimates are free.
Schedule Your Richmond Hill Chimney Cap & Crown Estimate
If your Richmond Hill chimney crown is spalling, your cap is rusted or missing, or you’ve smelled something in an upstairs room you can’t trace, call (855) 410-4917. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, the inspection comes with photos, and the written estimate sets the final price. One company for the cap, the crown, and whatever the roof inspection turns up underneath.
Written by the team at Chimney Sweep Forest Hills.